What does the product example demonstrate?
Schneider Electric's VAMP 321 guidance describes latched contacts that require a manual release. The existence of an explicit reset operation is a reminder to check the actual configured behavior; it is not a universal description of every relay output.
Substation Drafting is independent and is not affiliated with Schneider Electric. This article records approved design information and intentionally gives no reset button sequence, settings change or instruction for operating energized equipment.
Sources: Schneider Electric: How to release latched contacts on the VAMP 321 relay
Which references should the drawing check connect?
Use the exact device, firmware or configuration basis where relevant, output identifier and approved logic or function diagram. Keep a physical terminal reference separate from the logic that drives it and the mechanism that resets a latched condition.
| Field | Record | Review |
|---|---|---|
| Output identity | Device tag, output and terminals | Match the same physical point |
| Normal state | Approved contact designation and reference state | Do not infer memory behavior |
| Latching basis | Approved logic or configured mode | Keep the evidence revision |
| Reset source | Approved local, remote or logic reference | Do not invent authority to operate |
| Indication | Approved alarm or status mapping | Separate display from output state |
| Review | Engineering disposition and affected sheets | Preserve conflicting inputs |
Why can the triggering input and output state differ?
Illustrative example. A fictional approved logic description says output O-A latches on event E-A and remains operated until a separate approved reset condition. A drawing reviewer sees that E-A is no longer active and assumes the output must have returned to normal.
That assumption omits the stated memory behavior. The reviewer records the mismatch and asks the responsible engineer to reconcile the logic and drawing notes. The example supplies no real relay settings, reset command, safety interlock or permission to clear a trip.
What should be retained before issue?
Keep the engineer-approved output and reset descriptions, the actual configuration reference and the relevant sheet cross-references. If the sources disagree, show an open item instead of relabelling a contact or inventing a reset path. Verify linked alarm and control references against the same approved revision.
Drawing consistency does not establish that a reset is safe, that a fault has cleared or that equipment may be re-energized. Engineering sign-off is performed only by the registered engineer on the job. Authorized operations follow the actual site process.
Common questions
What else should the bid team know?
Does NO or NC alone describe latching?
No. Record the approved operating and reset behavior separately.
Does the trigger clearing prove the latched output reset?
Not when the approved logic retains the state until another condition.
May the drafter choose a reset path?
No. Obtain the approved engineering basis and preserve unresolved inputs.
Primary sources
- How to release latched contacts on the VAMP 321 relaySchneider Electric